| English | 中文 | Contact us
 
Product information
Silicon rubber
电子元器件用硅胶
Electronic components retardant silicone
Fine Chemicals
Liquid silicone rubber
Organic fluorine
Series of organic silicon
Epoxy adhesive
Recommend hot product
One-component RTV silicone rubber GD-453L
LX-9Q急速固化环氧胶粘剂
全氟甲基乙烯基醚(PMVE)
Electronic components retardant silicone
Changzhou Begaddy Rubber Co.,Ltd
Address:Rom 1408,No.266,Haoyuan,Middle Tongjiang,Xinbei District, Changzhou City
Tel:0519-81232220
Fox:0519-81232226
E-mail:Begaddy@Begaddy.com
Your position is right nowHome  >> Product > productlist > Silicon rubber
Silicon rubber GD-480

Features

GD-480 belong to a neutral  one-component RTV silicone rubber products, has excellent thermal conductivity,and play a role in cooling heating element heating element can heat rapid conduction and low voltage power products are widely used in communication and other heat and other high-power devices to heat.electrical insulation properties, excellent adhesive properties and sealing properties. If meatal products vulcanized non-corrosive,easy to use,can be used long-term in the temperature rang of -60~200℃,in addition, also has excellent resistance to UV resistance,aging resistance,ozone and other characteristics.

Technical parameters

Exterior 

White 

Tack free time

≤30

Thermal conductivity(W/M·K)

    ≥1.0~2.0

Dielectric strength(kV/mm)

≥15

Hardness (HA)

≥35

Tensile strength (MPa)

≥1

Relative elongation (%)

≥80

Usage

Adhesive seal

with ethanol or acetone to be coated the yuan is surface dust,oil spill cleaned upon solvent evaporation plastic extrusion from the hose,and construction. The mixture was allowed to stand at room temperature for 24 hours can be moved, and complete curing takes one week. Clean adhesioned after solvent evaporation, the GD-480 small amount evenly applied to the adhesive surface, then the composite bonding pieces together exert a certain pressure for 72 hours.

Thick layer of seal

GD-480 vulcanized is gradually rely on contact with air, water and gas outside to the inside ,more than 5mm coating preferably in batches construction methods that each scratch about 3 mm, vulcanized before continuing to be the next construction.

Precautions

1.use of this product should be packing tube after plastic lid tightly to prevent the remaining plastic tube curing..
2.Eye irritation,careful not to get the eyes,if inadvertently get the eyes should be immediately washed with tap water and then consult a doctor.

Packaging,Storage and transportation

1.100g aluminum tube packaging or 300ml plastic tube packaging.
2.This product is placed in cool.dry environment preservation;storage period of six months.
3.This product is non-dangerous goods transport.

Index | Product | Article | Guest | Contact us
All rights reservedChangzhou Begaddy Rubber Co.,Ltd Sue for the record, :Sue ICP for 14032272